Olifant: Tusk Completed

The first tusk/canister is now complete, and is shown below on the right. The piece on the left is the casting with the aluminum powder straight out of the mold.


To finish it I sanded, buffed and polished it, then gave it a coating of antiquing. After it dried I screwed in the eight black steel bolts, and attached the coiled wire thingamajiggy on the right. Now it kind of looks like a bomb!

Olifant: Tusk, Take 2

While going through my collection of yard sale finds, I came across the flashlight shown below. I bought it because I loved its Buck Rogers futuristic look.

Since I've been working on the new Olifant tusk canister, it ocurred to me that the missile end could make a good finial for such a canister. And as I wasn't feeling all tingly inside about the versison I had been working on I decided to begin again with the flashlight as my starting point.


After molding the flashlight in RTV silicone and casting it in urethane resin, I cut out a series of acrylic discs and stacked them around the "missile".


The flashlight has nine vertical grooves spaced evenly around its circumference except for one place, which is wider than the other eight. I decided to add a piece of hardware there above the discs, bigger than the other eight screws which will be added to each finished casting. Then I coated the acrylic discs with urethane resin to seal them and smooth them out so that the canister will rotocast more easily (that's the white stuff in the picture above).


As it was difficult to see what I really had with the white and black and gray all contrasting, I sprayed a coat of white sandable primer, which makes it much easier to view.

Olifant: Tusk Construction

In addition to giving Pachydermos' offspring a new set of tusk canisters, I have decided to also give him a new trunk hose. To celebrate that differentiation I have named him Olifant, a variation of the word Elephant.

I have molded the assemblage of brass parts (on the left) and cast it in a gray urethane resin (on the right).

Here I have sanded irregularities, filled cracks with Bondo™, and engraved the cap to match the hex acorn nut that will sit on top and hold the canister against the mask. I've also drilled and mounted twelve brads, which are meant to simulate rivets holding the top to the case.

Pachydermos Tusk Construction

I'm going to give Son of Pachydermos new tusks, different from his father's, just to make him more interesting. I want them to look a bit like a steampunk boiler, but still tusk shaped.

I've pulled out a box of mostly brass parts that I've collected over the years, most of it from yard sales, but some just hardware store purchases.

Here I've chosen the parts I'm going to start with: A paper cup, a brass doorknob (that I just bought today at a local flea market for 50¢), an acorn nut, and two other parts that I can't identify.

By cutting out the bottom of the cup (and turning it upside down) the doorknob fit right into the hole. The other metal parts are just stacked on top of the knob. I plan on molding and casting this combination, then adding screws and other bits and pieces to punkify it.